2010 Dodge Charger Engine Light On

The throttle control warning light will normally light up briefly each time you start your vehicle and then go off.

2010 dodge charger engine light on.

If it doesn t you may see a wrench light or the check engine light instead. The following are warning lights and indicators found in vehicles built by dodge. Four problems related to check engine light on have been reported for the 2010 dodge charger. When retrieving dodge check engine light codes with an obd ii scan tool proceed as follows.

If your dodge check engine light is on and you get code p0404 it means that your dodge exhaust gas recirculation egr valve is operating out of range. Connect scan tool to the 16 pin data link connector dlc located near the steering column. You should take your dodge to a qualified mechanic to have the problem looked at and if necessary repaired before you reset the light. Turn the ignition on.

The purpose of the egr valve is to recirculate exhaust gases and send them back into the engine to lower the nox emissions. The check engine light illuminates on the control panel on the dashboard of your dodge when the on board diagnostic computer reads a trouble code from the engine. Click a link to learn more about each one. A check engine light can indicate a broad spectrum of problems with your 2008 dodge charger.

Please also check out the statistics and reliability analysis of the 2010 dodge charger based on all problems reported for the 2010 charger. The most recently reported issues are listed below. But if the light stays on or comes on while you re driving your car needs some love. The connector may have a removable cover.

This is nothing to worry about. You can reset the.